MICRO QUICK FIST clamp - Item #30030

$8.95

• Holds objects from 1/2" to 7/8” (13 to 22mm) in diameter. • Use either #6 flathead screw or bolt and a small washer (Do Not Over-tighten). • Each clamp supports a safe working load of 13lbs (6 kilos). • 2 clamps support 26lbs (12 kilos). • Mounting Area: 1 3/8" x 1 1/8"

Four Clamps Per Package
More Information
Grip Size - (The diameter of the object you are mounting) 1/2" to 7/8” (13 to 22mm)
Package Contents Four Clamps Per Package
Installation Instructions View / Download (PDF)

Two good ways to install QUICK FIST clamps are with Jacknuts® or rivetnuts.


Jacknut® Threaded inserts

Jacknuts are a fast and inexpensive way to put a nut into a place where there is no access for a traditional nut. After drilling a hole, the Jacknut is inserted and then tightened with the proper sized bolt. The “legs” of the Jacknut collapse to grip the inside of the mounting surface, leaving a permanent, reusable nut in the hole.


Rivetnuts (best known brand is Nutserts®)

These are nuts that can be riveted into drilled holes. Like Jacknuts these are particularly good to install where the underside of a mounting hole cannot be accessed. To install rivetnuts, you will need a special type of rivet gun or find a garage that will install them for you.



Copyright © QUICKFIST - All Rights Reserved